Prusa style vs CoreXY

Anything goes! Cheap or expensive, FDM or SLA, DIY or Commercial.
User avatar
lowfat
Posts: 30
Joined: Thu Jun 15, 2017 3:36 am

Re: Prusa style vs CoreXY

Post by lowfat » Mon Sep 25, 2017 6:01 pm

I bought 10mm for X and Y and 12mm for the Z. I did a few cuts on the extrusions so I could fit them in my vehicle, but the shortest is still over 6ft (1.8M).

Google hasn't found me much for CoreXY's that use 3030, besides ones using linear rails or v-slot.

Tsunamijuan
Posts: 21
Joined: Mon Jun 19, 2017 5:34 pm

Re: Prusa style vs CoreXY

Post by Tsunamijuan » Mon Sep 25, 2017 8:22 pm

lowfat wrote:
Mon Sep 25, 2017 6:01 pm
I bought 10mm for X and Y and 12mm for the Z. I did a few cuts on the extrusions so I could fit them in my vehicle, but the shortest is still over 6ft (1.8M).

Google hasn't found me much for CoreXY's that use 3030, besides ones using linear rails or v-slot.
I'll look at the entire hypercube evo parts list today. Then see If I can make use of what hes already has used for X and Y axis's and carriage so that you don't have to go repurchasing stuff. Printed parts are obviously quite easy to replace but nobody wants to rebuy parts if they can avoid it.

X7JAY7X
Posts: 1
Joined: Tue Aug 07, 2018 8:22 pm

Re: Prusa style vs CoreXY

Post by X7JAY7X » Tue Aug 07, 2018 8:29 pm

Old post but did you ever figure out how to convert a Hypercube to have horizontal X rods?

User avatar
louis.blom
Posts: 2
Joined: Fri Aug 10, 2018 9:51 pm

Re: Prusa style vs CoreXY

Post by louis.blom » Fri Aug 10, 2018 9:58 pm

on the corexy why not let the head also run on the z axis, while the bed remains stationary, can be done by turning motors around on z, and extending frame for complere asemble to run in side frame?

User avatar
Moorviper
Posts: 232
Joined: Wed May 24, 2017 1:19 pm
Location: Hessen/Rhön - Germany
Contact:

Re: Prusa style vs CoreXY

Post by Moorviper » Fri Aug 10, 2018 9:59 pm

Z wobble ?

User avatar
louis.blom
Posts: 2
Joined: Fri Aug 10, 2018 9:51 pm

Re: Prusa style vs CoreXY

Post by louis.blom » Fri Aug 10, 2018 10:21 pm

the 3d geco printer runs that way see, https://www.aliexpress.com/store/all-wh ... 75020.html
they use band but i think z motor will by more stable

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest