Anything goes! Cheap or expensive, FDM or SLA, DIY or Commercial.
- Posts: 13
- Joined: Thu Jul 06, 2017 6:00 pm
- Location: Warracknabeal Victoria Australia
One thing I have found with Cura is the when you load a new material profile it sometimes puts the Filament diameter to 2.85mm if you change it to 1.75mm it normally Fixes the problem.FellCrustacean8 wrote: ↑Thu Jul 13, 2017 5:39 amI figured out what caused it. For some reason on default settings cura was forcing way to much filament through. It was kind of odd. Considering it always worked fine before, there weren't any of the usual signs like extruder stepper motor stalling. But it was doing it to the extreme. I cut the extrusion down to 42% of regular speed and now it is working fine.
Who is online
Users browsing this forum: No registered users and 5 guests