MK42 clone wiring help

Electronics, Components etc
Post Reply
Posts: 2
Joined: Fri Jun 23, 2017 5:02 pm

MK42 clone wiring help

Post by peters6s » Tue Jul 18, 2017 7:10 pm

I received my MK42 heating bed and need help, I see that i have a place to install the LED which I need search and buy, but I see something say R1 - 1K marked. means that I need find a resistor and solder between the two tabs? or will it work without it? I am building a clone mk2 following Prusa assembly instructions and some videos. I found all parts which are in order and order this Heat bed from Orballo which looks real close to the HB in Prusa units

User avatar
Posts: 85
Joined: Mon May 22, 2017 2:33 pm

Re: MK42 clone wiring help

Post by PartTimeRonin » Wed Jul 19, 2017 4:45 am

That resistor is for LED that you want to install, if you don't need LED then you can skip resistor too.

Posts: 224
Joined: Thu Jun 15, 2017 10:24 am

Re: MK42 clone wiring help

Post by slippyr4 » Wed Jul 19, 2017 9:35 am

The LED and resistor are just indicators that the bed is powered and are optional.
Self-built Prusa i3 MK2 clone
My things:
My Prusa firmware port for ramps & MKS :

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests