Opinions and expertise on control boards

Electronics, Components etc
JacobLindsay
Posts: 14
Joined: Thu Sep 06, 2018 1:51 am

Re: Opinions and expertise on control boards

Post by JacobLindsay » Fri Sep 07, 2018 7:56 pm

I should have mentioned I am doing an h bot setup. With the Bowden setup and minimal weight on the carriage I wouldn’t see the nema17 having an issue with that. The bed will be stationary and the carriage will move for all axis. The threaded rod will be square or acme rod with graphite guides just like in a lathe setup so i think that would be fine. If not I would prefer to have more teeth on the drive gears but I don’t know how to adjust the firmware for that.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest