E3D volcano chinese knockoff keep jaming

Have an issue you can't figure out on your own?
Post Reply
Lundev
Posts: 1
Joined: Sun Sep 16, 2018 6:44 pm

E3D volcano chinese knockoff keep jaming

Post by Lundev » Sun Sep 16, 2018 7:33 pm

Hi,
I have a problem with my chinese copy of an e3d vocano, It jams after every succesfull print.
When I clean the hot end and start a print it complete nicely but when I try another one after it jams instantly or in the 5-10 first layers.
I can remove the PTFE tube and filament without issue when it jams but the filament is not straight: there is a bump about 1 cm after the end of the PTFE tube (I running a bowden setup).
I dissambled the hot end and followed the e3d guide to mount it but the issue appeared after one succesful print again.
Do you have any ideas how to fix it ?
Thanks in advance

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest