Have an issue you can't figure out on your own?
-
ericr6
- Posts: 1
- Joined: Tue Apr 10, 2018 5:44 pm
Post
by ericr6 » Tue Apr 10, 2018 8:03 pm
I'm having a reoccurring issue with my Tevo Tarantula. When printing say a calibration cube I dont see the lines but when doing anything with holes or curves I see random verticle lines. It will usually be a line or a group of lines that are thicker than the rest of the object.
Tevo Tarantula
.4 nozzle
.3 or .2 layer height( tried both)
e-sun pla+
205/60
slic3r
Thanks,
Eric
-
Stefan
- Posts: 223
- Joined: Thu Jun 15, 2017 12:46 am
Post
by Stefan » Wed Apr 11, 2018 4:49 am
Hi Eric,
What I think you are seeing is short spurts of over extrusion caused by lots of retractions. If you look at your sliced model, compare the extruder path with the actual model. If the thick parts are at the beginning of the layer, that's your culprit. Reduce or turn off retractions.
Also looks like you may have a little z-wobble.
-Stefan
Who is online
Users browsing this forum: No registered users and 1 guest