Rumba TMC2130 Debug Pins

Have an issue you can't figure out on your own?
Post Reply
na7kr
Posts: 2
Joined: Mon May 07, 2018 7:08 am

Rumba TMC2130 Debug Pins

Post by na7kr » Tue May 08, 2018 5:33 am

Where do you connect extruder debug pins?
What would you do with 3D Touch? or debug pin wire is Z-min if 3D-Touch is using?
Can I use Z-Max and what do I nned to change?

I have:
#define X_STEP_PIN 17
#define X_DIR_PIN 16
#define X_ENABLE_PIN 48

#define Y_STEP_PIN 54
#define Y_DIR_PIN 47
#define Y_ENABLE_PIN 55

#define Z_STEP_PIN 57
#define Z_DIR_PIN 56
#define Z_ENABLE_PIN 62

#define E0_STEP_PIN 23
#define E0_DIR_PIN 22
#define E0_ENABLE_PIN 24

#define E1_STEP_PIN 26
#define E1_DIR_PIN 25
#define E1_ENABLE_PIN 27

#define E2_STEP_PIN 29
#define E2_DIR_PIN 28
#define E2_ENABLE_PIN 39

//
// Trinamic 2130 ChipSelect pin definitions
//
#define X_CS_PIN 30 // Arduino pin 31 = Mega PC6/A14
#define Y_CS_PIN 31 // Arduino pin 30 = Mega PC7/A15
#define Z_CS_PIN 14 //
#define E0_CS_PIN 15 //
#define E1_CS_PIN 63
#define E2_CS_PIN 64
Kevin

helensdad
Posts: 2
Joined: Thu May 24, 2018 6:50 pm

Re: Rumba TMC2130 Debug Pins

Post by helensdad » Thu May 24, 2018 10:46 pm

I am also in need of help with this subject...

na7kr
Posts: 2
Joined: Mon May 07, 2018 7:08 am

Re: Rumba TMC2130 Debug Pins

Post by na7kr » Mon May 28, 2018 5:43 am

Sill cannot make it work yet.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests