Search found 1 match

by housey5450
Fri May 04, 2018 10:23 am
Forum: Software
Topic: Prusa firmware for RAMPS Prusa i3 clones with MK42 beds
Replies: 196
Views: 35928

Re: Prusa firmware for RAMPS Prusa i3 clones with MK42 beds

Hello, I have just upgraded to a Mk42 heatbed and installed the firmware, however It is not working at all. I have Ramps 1.4. When the printer is on, the Z motors are constantly enabled, with Y and X disabled. When I connect through repetier I get: 09:08:04.730 : No start signal detected - forcing s...