Search found 6 matches
Search found 6 matches • Page 1 of 1
- Tue Aug 01, 2017 5:52 pm
- Forum: 3D Printers
- Topic: Relationship between nozzle size, layer/nozzle height, print quality, print speed
- Replies: 14
- Views: 19548
Just to add something for a new person, there are layer hights that will work better or more consistent on your specific printer due it's mechanical properties. I mean by that that it's possible that your print result could be better with a layer hight of 200 micron instead of 150 micron for example...
OK I guess it's already to late for you since the post is now 2 months old and no one answered your questions First things first the aluminium plate should be a cast (fine) milled aluminium plate that is very important, it results in a metal plate with a minimal on stress that expands evenly in all ...
- Thu Jun 22, 2017 5:43 pm
- Forum: Software
- Topic: Infills with a bigger second nozzle, how?
- Replies: 8
- Views: 1157
There is a setting that could help you in some way, under the tab "supports" called "Print Support Every X Layers" If you set it to Print Support Every 2 Layers for example and use a regular layer hight of 0,4 mm on you support extruder it will print every 2nd layer with the double layerhight so 0,8...
Well ... to shorten the discussion right from the start linear guide rails are better :P. They are overall more sturdy, have fixing points every couple centimeters (linear guide rails should normaly be mount on a sturdy frame instead of being a part of the frame themself), twist resistant and most i...
solveable release/(stick) agent aka PVA based glue or hairspray help wit that. Those are normally used, to get filament stick better to thebuild plate but as these materials are not that tough by themself and water solveable you can use them as a release agent, too. The regular gluestick is the best...
- Thu Jun 01, 2017 5:12 pm
- Forum: Help requests / Purchasing assistance
- Topic: Severe underextrusion with PLA, ABS prints perfectly
- Replies: 4
- Views: 686
I don't know how hard it is on your printer but try a cold pull. Heat up your hotend feed some strong filament I like to use PET-G but plain PLA works, too. After heat up let the nozzle cool down to a low temperature as 70°C or room temperature (a bit hoter can make the pull easier ... but I would t...