Search found 8 matches

by Corde
Tue Jan 23, 2018 12:18 pm
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

And should i solder the CFG5 or just leave in peace.
by Corde
Tue Jan 23, 2018 11:49 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

I read it i want to use the SPI mode.
In this case i need to soldering the CFG4 and desoldering the SPI part.
Right?
by Corde
Tue Jan 23, 2018 10:15 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

And these Fystex driver overtemperature caused by this little soldering "error"?
I mean when i dont use in spi mode so just stick the stepper driver in the board a few minutes later it will be too hot and start skipping steps.
And what mA do you recommend for it?
by Corde
Tue Jan 23, 2018 10:10 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

Thank you. Do you ahve a full guide or video how should i do it?
by Corde
Tue Jan 23, 2018 9:51 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

I just soldered the 4 pins and the one pins for the endstop.
by Corde
Tue Jan 23, 2018 9:49 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

I just soldered the 4 pins and the one pins for the endstop.
by Corde
Tue Jan 23, 2018 8:59 am
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Re: Anet A8 Ramps 1.4 TMC2130

Okey.

I have TMC drivers from Fysetc.com
And when i just connect the stepepr driver and and wiring like this i also get the error message.
No stepepr motor no end stops connected, just the stepper drivers.
by Corde
Mon Jan 22, 2018 4:31 pm
Forum: Hardware
Topic: Anet A8 Ramps 1.4 TMC2130
Replies: 17
Views: 5624

Anet A8 Ramps 1.4 TMC2130

Hello guys, I did Tom's guide about the TMC2130 stepper driver with the Ramps 1.4 board. But when i start my printer i got this error message: READ: 00:00: X driver overtemperature warning! (600mA) READ: READ: Y driver error detected: READ: overtemperature READ: short to ground (coil A) READ: short ...