Search found 6 matches

by alex 3d
Sat Jul 28, 2018 12:43 am
Forum: Off-topic
Topic: Benchy carrying Lunar Eclipse 2018
Replies: 1
Views: 1754

Re: Benchy carrying Lunar Eclipse 2018

p.s. Benchy base was subjected to experiments with part cooling fan on and off ;)
by alex 3d
Sat Jul 28, 2018 12:42 am
Forum: Off-topic
Topic: Benchy carrying Lunar Eclipse 2018
Replies: 1
Views: 1754

Benchy carrying Lunar Eclipse 2018

Enjoy Benchy carrying Lunar Eclipse of July 2018 :)
MoonBenchy.png
MoonBenchy.png (183.01 KiB) Viewed 1754 times
(license CC BY-NC-ND)
by alex 3d
Sun May 06, 2018 10:52 pm
Forum: Hardware
Topic: Issues with TMC21030 on the GT2560
Replies: 4
Views: 3325

Re: Issues with TMC21030 on the GT2560

To be more specific, the motor does not react, I get a status 0xFFFFFFFF when using the TMC debug command (M122): Driver registers: X = 0xFF:FF:FF:FF If additionally, I've activated the MONITOR_DRIVER_STATUS flag, then Marlin reports critical temperature, short to ground for both coils and freezes t...
by alex 3d
Sun May 06, 2018 10:45 pm
Forum: Hardware
Topic: Issues with TMC21030 on the GT2560
Replies: 4
Views: 3325

Re: Issues with TMC21030 on the GT2560

OK, the axis inversion worked great. Thanks for that. TMC2130 on the GT2560 not so great. Here's what I did in the board config file (I have RevA+): #if ENABLED(HAVE_TMC2130) // define subscriber select pins #define X_CS_PIN X_MAX_PIN // define SPI communication pins #define TMC_USE_SW_SPI #define T...
by alex 3d
Tue Feb 06, 2018 10:16 pm
Forum: Hardware
Topic: Issues with TMC21030 on the GT2560
Replies: 4
Views: 3325

Re: Issues with TMC21030 on the GT2560

Wow, thanks :)

I'll start implementing it as soon as I can. Will post the result as I get them

Thanks again :)
by alex 3d
Sun Feb 04, 2018 10:53 pm
Forum: Hardware
Topic: Issues with TMC21030 on the GT2560
Replies: 4
Views: 3325

Issues with TMC21030 on the GT2560

Hi, I was following Tom's video and trying to install my tmc2130 boards (watterott) on a GT2560 "motherboard" when I noticed two issues: 1. the carriages move in reversed directions (on all axes I mounted them) 2. there are not enough pins (AUX3) on the GT2560 to connect SDI Does anyone know how to ...