Search found 85 matches

by PartTimeRonin
Sun May 28, 2017 5:42 am
Forum: Hardware
Topic: Azteeg X5 GT 32bit - experiences, remarks, etc.
Replies: 10
Views: 3751

Re: Azteeg X5 GT 32bit - experiences, remarks, etc.

Here is an option for you to consider if you looking for Smoothie with Pololu driver Cohesion3D ReMix Not going to say which one is better, you need to choose what suits you best. Edit : didn't see that you want to go with Bigfoot TMC2660 driver, so I guess you need to use Azteeg. Maybe check out Du...
by PartTimeRonin
Sun May 28, 2017 5:33 am
Forum: Hardware
Topic: Where to buy PEI / ULTEM sheet, especially BIG ONES
Replies: 5
Views: 1214

Re: Where to buy PEI / ULTEM sheet, especially BIG ONES

If you can go with a very thin one it's not that expensive(0.07mm for $24 from cshyde)
When you go something like 0.5-1mm it quite a lot of money.

But sometime if you look around in Amazon, ebay, Aliexpress you might find a good deal.
by PartTimeRonin
Thu May 25, 2017 2:16 pm
Forum: Hardware
Topic: Installed E3D on my wanhao, but it jams occassionally
Replies: 10
Views: 1701

Re: Installed E3D on my wanhao, but it jams occassionally

I used to have problem when usually I print PETG and switch back to PLA I get underextrusion almost everytime especially when rapid retraction happen. I find that PLA need more extruder idler bearing tension than PETG and because I adjust it just right for PETG so PLA will slip. Tight it more for PL...
by PartTimeRonin
Wed May 24, 2017 5:55 pm
Forum: Help requests / Purchasing assistance
Topic: Issues with I'm not sure what it's called?
Replies: 8
Views: 1059

Re: Issues with I'm not sure what it's called?

ambient temperature mean the room temperature that the printer is in.
Unless you use enclosure.
by PartTimeRonin
Wed May 24, 2017 5:31 pm
Forum: Hardware
Topic: Dont plug your heatbed into connector for extruder 2!
Replies: 4
Views: 770

Re: Dont plug your heatbed into connector for extruder 2!

Should still work, you probably just overloaded the connectors.