Error: Printer halted. kill() called! on homing (Marlin 1.1.9)

3D Modelling, Slicing, Hosts and Management
Post Reply
Arakahn
Posts: 1
Joined: Fri Sep 21, 2018 2:15 am

Error: Printer halted. kill() called! on homing (Marlin 1.1.9)

Post by Arakahn » Fri Sep 21, 2018 2:49 am

Help!

Building my first printer, and every time I try to home any axis (or start a print job for that matter), I get this error when the axis arrives at it's home position. I have no mechanical endstop, using a MKS GEN1.4 board.

Attached here is my config and my printer settings in Repetier Host. If anyone is able to help I'll be eternally grateful!

https://www.dropbox.com/s/ccpg5qrzxdodx ... ion.h?dl=0
Attachments
Capture.JPG
Capture.JPG (40.13 KiB) Viewed 308 times

oakdesign
Posts: 109
Joined: Thu Jun 15, 2017 10:21 am

Re: Error: Printer halted. kill() called! on homing (Marlin 1.1.9)

Post by oakdesign » Fri Sep 21, 2018 1:13 pm

I have no mechanical endstop, using a MKS GEN1.4 board.

Code: Select all

#define USE_XMIN_PLUG
#define USE_YMIN_PLUG
#define USE_ZMIN_PLUG
On the one Hand you are saying you don't have endstops on the other Hand you are defining endstops in the configuration.h. So how should the Firmware be able to perform a G28?
If you don't have endstops Marlin won't know the Position of your printhead after power up. So the only way do set a home without endstops is by manually moving your printhead to your desired home Position and then issue a M92 X0 X0 Z0 command
Opa's bester Rat: Probieren geht über Studieren, Grandpas best advice: the proof of the pudding is in the eating

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests