Page 1 of 1

Rumba TMC2130 Debug Pins

Posted: Tue May 08, 2018 5:33 am
by na7kr
Where do you connect extruder debug pins?
What would you do with 3D Touch? or debug pin wire is Z-min if 3D-Touch is using?
Can I use Z-Max and what do I nned to change?

I have:
#define X_STEP_PIN 17
#define X_DIR_PIN 16
#define X_ENABLE_PIN 48

#define Y_STEP_PIN 54
#define Y_DIR_PIN 47
#define Y_ENABLE_PIN 55

#define Z_STEP_PIN 57
#define Z_DIR_PIN 56
#define Z_ENABLE_PIN 62

#define E0_STEP_PIN 23
#define E0_DIR_PIN 22
#define E0_ENABLE_PIN 24

#define E1_STEP_PIN 26
#define E1_DIR_PIN 25
#define E1_ENABLE_PIN 27

#define E2_STEP_PIN 29
#define E2_DIR_PIN 28
#define E2_ENABLE_PIN 39

//
// Trinamic 2130 ChipSelect pin definitions
//
#define X_CS_PIN 30 // Arduino pin 31 = Mega PC6/A14
#define Y_CS_PIN 31 // Arduino pin 30 = Mega PC7/A15
#define Z_CS_PIN 14 //
#define E0_CS_PIN 15 //
#define E1_CS_PIN 63
#define E2_CS_PIN 64
Kevin

Re: Rumba TMC2130 Debug Pins

Posted: Thu May 24, 2018 10:46 pm
by helensdad
I am also in need of help with this subject...

Re: Rumba TMC2130 Debug Pins

Posted: Mon May 28, 2018 5:43 am
by na7kr
Sill cannot make it work yet.