Problems with diagonal lines

Have an issue you can't figure out on your own?
Post Reply
User avatar
Posts: 1
Joined: Fri May 11, 2018 11:13 pm

Problems with diagonal lines

Post by GlennPierce » Fri May 11, 2018 11:45 pm

Hi I have a Wanhao I3 duplicator but have started seeing some odd diagonal lines on the surface of a print.
problem.png (1.59 MiB) Viewed 497 times
I have tried increasing the flow rate. Changing the extrusion temperature. I am printing the item at 100% infill as well to eliminate that as an issue.
Has anyone seen this type of thing before ?

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests