Prusa firmware customisation

Have an issue you can't figure out on your own?
Post Reply
Posts: 3
Joined: Fri Jun 16, 2017 1:37 am

Prusa firmware customisation

Post by MIKEYMCC » Fri Oct 26, 2018 3:19 pm

I have created a monster by basically turning a cr-10 into a Prusa mk2.5. So it basically has the cr-10 frame and bed and the rest would be the mk2.5. It's on thingiverse as crearibo. I am using the prusa firmware version 3.4.1 and I need help changing the points that it uses to probe the bed for bed levelling, it still uses the smaller area and I want the 300x300 space probed instead.

Anyone got tips on what to change in firmware as I changed settings in configuration_prusa.h for mesh leveling and it made no difference.

User avatar
Posts: 232
Joined: Wed May 24, 2017 1:19 pm
Location: Hessen/Rhön - Germany

Re: Prusa firmware customisation

Post by Moorviper » Fri Oct 26, 2018 6:20 pm

i have to look what i did @my_printer

but for today i am done ;D
photo_2018-10-26_18-19-49.jpg (121 KiB) Viewed 2429 times

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests