Zits occuring on every layer

Have an issue you can't figure out on your own?
orbitalair
Posts: 9
Joined: Mon Jan 29, 2018 3:03 pm

Re: Zits occuring on every layer

Post by orbitalair » Tue Jan 30, 2018 3:01 pm

Also I would try isolating the issue by test type.

I got a much simpler retraction test from thingiverse to tune my retraction distance.
https://www.thingiverse.com/thing:2535405

Get the retraction configured then try a larger print.

This helped my quite a bit, and is much faster than the xyz cube.

Allmetal e3ds clones will jam up with too much retraction, mine did, then Id get something like a 10% fill layer, ugh.
I ended up at 2mm with 50mm/s retract rate for pla.

Good luck.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests