tevo tornado problems

Have an issue you can't figure out on your own?
Post Reply
User avatar
Posts: 1
Joined: Fri Feb 23, 2018 11:17 pm

tevo tornado problems

Post by RyanRagasa » Fri Feb 23, 2018 11:34 pm

i have been having problems with layer shifting on my tevo tornado. since im new to 3d printing i have no idea what to do about it. i did some research on what could be causing it but everything that i think might be causing it should not be the problem. i set the drivers to .99 volts and the layer shifting improved a little. on the tevo tornado group on thingiverse someone suggested adjusting the acceleration to about 3000 so i did. the problem with that is that whenever i try to print, the acceleration goes back to 500 even when i have saved the settings. could it be that i just have a bad control board?

User avatar
Posts: 232
Joined: Wed May 24, 2017 1:19 pm
Location: Hessen/Rhön - Germany

Re: tevo tornado problems

Post by Moorviper » Sat Feb 24, 2018 4:27 am

Doesn't tevo provide support?

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests