Page 1 of 1

MK42 alignment on a custom frame

Posted: Sat Dec 01, 2018 1:19 am
by Moorviper
This is what i changed to get the MK42 aligned on my printer.
These are the set screws within the firmware:
Bildschirmfoto 2018-12-01 um 01.10.26.png
Bildschirmfoto 2018-12-01 um 01.10.26.png (26.18 KiB) Viewed 602 times
Bildschirmfoto 2018-12-01 um 01.11.17.png
Bildschirmfoto 2018-12-01 um 01.11.17.png (124.41 KiB) Viewed 602 times
Bildschirmfoto 2018-12-01 um 01.11.53.png
Bildschirmfoto 2018-12-01 um 01.11.53.png (58.4 KiB) Viewed 602 times