Page 1 of 1

Tronxy X5S

Posted: Wed Feb 21, 2018 12:22 pm
by beemergb
Hi 3d people , I hope you can help me in my quest to get my Tronxy X5S to run ! The Marlin tells me I have the wrong library ,I try to update it with the correct library U8GLIB but it does not respond always false etc . And also Marlin tells me to replace the exsiting board with a Sanguino one , I presume this means Sanguinololu 1.2 ? I copy and paste the new one in , as Tom showed us on You Tube , also to no avail ! I would love to use my printer I have so many Projects but all I can do is write to people all over the world and ask for help : Hope this will all Change and I can get on printing , all the best Harry

Re: Tronxy X5S

Posted: Fri Mar 09, 2018 8:57 am
by beemergb
Hi 3D people ,I had a a large problem trying to get the TronxyX5S to work , mainly because I use Simplify 3D as my slicer and they did not Support this model .But I asked them and wham !!! Those lovely people sent me a zip with the new Support I needed for Tronxy ! Fantastic Service and very quick ,AND it works at last . Thank you again the Simplify 3D Team