Page 1 of 2

MK3 Firmware

Posted: Tue Mar 06, 2018 10:41 pm
by Veneficus
The most Hardware parts for a Prosa MK3 Clone are available on the Prusa Shop (Pinda2 and Filament Sensor).At the moment I have a look on the MK3 Firmware. And the I have a Problem with the Pinout. Does someone know which function that is and if that works on a mis 1.4 Board with SPI controlled TMC2130 Boards?
#define MOTOR_CURRENT_PWM_XY_PIN 46
#define MOTOR_CURRENT_PWM_Z_PIN 45
#define MOTOR_CURRENT_PWM_E_PIN 44

Re: MK3 Firmware

Posted: Wed Mar 07, 2018 2:22 am
by Moorviper
Have you links ?
:edit
Have you links for the pinda2 probe in the store ?

Re: MK3 Firmware

Posted: Wed Mar 07, 2018 9:18 am
by Veneficus
Veneficus wrote:
Tue Mar 06, 2018 10:41 pm
The most Hardware parts for a Prosa MK3 Clone are available on the Prusa Shop (Pinda2 and Filament Sensor).At the moment I have a look on the MK3 Firmware. And the I have a Problem with the Pinout. Does someone know which function that is and if that works on a mks 1.4 Board with SPI controlled TMC2130 Boards?
#define MOTOR_CURRENT_PWM_XY_PIN 46
#define MOTOR_CURRENT_PWM_Z_PIN 45
#define MOTOR_CURRENT_PWM_E_PIN 44

Re: MK3 Firmware

Posted: Wed Mar 07, 2018 11:57 am
by Veneficus
links ? Prusa Github there is the Firmware to download

Re: MK3 Firmware

Posted: Wed Mar 07, 2018 1:54 pm
by Moorviper
Sorry :D
Links for the Hardware in the Shop?

Re: MK3 Firmware

Posted: Mon Mar 12, 2018 11:00 am
by Veneficus

Re: MK3 Firmware

Posted: Mon Mar 12, 2018 12:36 pm
by Moorviper
ok this link is not public

Re: MK3 Firmware

Posted: Sat Apr 07, 2018 11:13 pm
by Veneficus
Done.

MK3 Clone läuft mit Prusa Firmware (aktuelle Version). Der Stealth Modus war ziemlich schwierig auf meine Motoren einzustellen aber er läuft 1a :mrgreen:

Re: MK3 Firmware

Posted: Wed May 23, 2018 11:08 am
by darthvader85
Which electronics hardware do you have used to clone the MK3?

Re: MK3 Firmware

Posted: Sat May 26, 2018 1:15 pm
by babboy
@Veneficus
Kannst mir erzählen wie du es geschafft hast.
aktuell bei mir Folgendes Problem.

XYZ Kalibrierung funktioniert mit Mk42 Bed
Mesh Bed leveling Funktioniert
Pinda2 mit Thermistor funktioniert
Lüfter Fan Mit Tacho Funktioniert

Nur ich kann nicht drucken
Führe ich die erste schicht Kalibrierung durch oder einen anderen Druck
Resetet sich der Drucker nach dem Leveling.
Meine Hardware
MKS Rumba
Firmware Prusa 3.2.1
Mfg babboy