Anet A8 Stock Vref from Potentiometer

Electronics, Components etc
Post Reply
Posts: 1
Joined: Fri Sep 28, 2018 10:18 pm

Anet A8 Stock Vref from Potentiometer

Post by Cr0n_j0B » Fri Sep 28, 2018 10:21 pm

Hey Everyone,

I'm new to the forum and have just a quick, I think Simple, question. I messed around with the stock Vref on my Anet A8 boards and want to set it back to the factory settings. Does anyone know what at setting is? My board only has one pot near the Z-motor wires.

Also, i read conflicting information about that pot managing vref for ALL motors or just the one Z motor that it's closest to. thoughts?


Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests