Page 1 of 1

Anet A8 Stock Vref from Potentiometer

Posted: Fri Sep 28, 2018 10:21 pm
by Cr0n_j0B
Hey Everyone,

I'm new to the forum and have just a quick, I think Simple, question. I messed around with the stock Vref on my Anet A8 boards and want to set it back to the factory settings. Does anyone know what at setting is? My board only has one pot near the Z-motor wires.

Also, i read conflicting information about that pot managing vref for ALL motors or just the one Z motor that it's closest to. thoughts?