Page 1 of 1

MK42 @24V (Orballo Printing)

Posted: Mon Dec 03, 2018 4:38 pm
by Moorviper
2018-12-03 16.28.40.jpg
2018-12-03 16.28.40.jpg (87.38 KiB) Viewed 254 times
wired for 24V 1.8 Ohm. 2+ Ohm would be better but it should do the job. (3.6 would be great)
@12V it was 1 Ohm so now it is doubled the power

Re: MK42 @24V (Orballo Printing)

Posted: Mon Dec 03, 2018 9:13 pm
by Moorviper
No burned traces.
the heating power is a little more than doubled.
22-100°C in 2,5 Minutes