Installed E3D on my wanhao, but it jams occassionally

Electronics, Components etc
kr15_uk
Posts: 6
Joined: Mon May 22, 2017 12:06 pm

Re: Installed E3D on my wanhao, but it jams occassionally

Post by kr15_uk » Sat Jun 03, 2017 2:50 pm

I do use different temperatures with different speed profiles. For example 210c on 40mm/s and 215c on 60mm/s to achieve the same layer adhesion and strength.

Also I'd recommend Vulcano upgrade for your E3D v6 if you are looking for speed.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest