Don't Clean your Buildtak with Acetone!

Electronics, Components etc
Post Reply
User avatar
pinkmouse
Posts: 4
Joined: Mon May 29, 2017 12:17 pm

Don't Clean your Buildtak with Acetone!

Post by pinkmouse » Sat Nov 04, 2017 12:45 pm

'...Cos everything sticks like F*** and rips up the surface when you try to remove the print!

Stick to IPA. You know it makes sense. ;)

User avatar
ido
Posts: 40
Joined: Wed Jul 12, 2017 10:09 pm
Location: Rotterdam - The Netherlands

Re: Don't Clean your Buildtak with Acetone!

Post by ido » Mon Nov 06, 2017 8:11 am

thanks for the tip :lol:

User avatar
Moorviper
Posts: 232
Joined: Wed May 24, 2017 1:19 pm
Location: Hessen/Rhön - Germany
Contact:

Re: Don't Clean your Buildtak with Acetone!

Post by Moorviper » Mon Nov 06, 2017 8:44 am

this also happens when you print TPE on PEI
(i used https://www.voelkner.de/products/979027 ... 0iEALw_wcB)

and you clean it with Acetone.
You can do it but have to clean it extremely good with IPA and water later.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest